Fabric weight standard test method for Mass Per Unit Area (weight) of fabric using ASTM Test Method D ASTM D Standard Test Method for Mass Per Unit Area (Weight) of Fabric1 – Download as PDF File .pdf), Text File .txt) or read online. ASTM D The ASTM D Basis weight test method covers four methods for the measurement of fabric mass per unit area (weight). It is applicable to most fabrics.
|Published (Last):||25 November 2012|
|PDF File Size:||5.20 Mb|
|ePub File Size:||5.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
Fabric Weight Testing using ASTM Test Method D
Work Item s – proposed revisions of this standard. Link to Active This link d377 always route to the current Active version of the standard. ASTM does not give any warranty express or implied or make any representation that astm d3776 contents of this abstract are accurate, astm d3776 or up to date. Measurements by this method do not include selvages and should be reported as such, unless a selvage allowance is specified.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. These test methods cover the measurement of fabric mass per unit area weight astm d3776 is applicable to most fabrics. It is informational only and not an official astm d3776 of the standard; the full text of the standard itself must be referred to for its use and application.
The results are considered to be applicable to the sample only astm d3776 not necessarily to astmm lot from which the sample was taken. Option A may be used for acceptance testing of commercial shipments since it has been used extensively in the trade.
ASTM D Basis Weight » SGS-IPS Testing
Referenced Documents d376 separately The documents listed below are referenced within the subject standard but are not astm d3776 as part of the standard. There are four approved options in the measurement of fabric mass per unit area: Unless otherwise specified, these results will include selvages and will be on the astm d3776 of conditioned fabric.
The values stated in each system may not be exact equivalents; therefore, each astm d3776 shall be used independently of the other. The last option is Option D which is intended for use with narrow fabrics as so designated by dd3776 trade. The second option astm d3776 Option B which is applicable to a full-width sample cut from a full piece, roll, bolt, or cut.
This abstract is a brief summary of the referenced standard. Historical Version s – view previous versions of standard. Option Astm d3776 on the other hand is applicable when a small swatch of fabric is sent to the laboratory to be used as atm test specimen. Combining values from the two systems may astm d3776 in non-conformance with the standard.